Intelligent DDoptics IFiber Control illuminated dot

What comes with the new DDoptics IFiber Control technology?

After the Luminous point IIUnfortunately, fine details such as the light unit are often skimped on. And this has far-reaching consequences! Not so with DDoptics. " More info follows the The latest technology from DDoptics - Made in Germany. A Light point with integrated control unit. Above all, this brings significantly more convenience and safety without having to change your mind.

You activate the Light pointThe choice of reticle and the associated mode of operation of the illuminated dot is of decisive importance when purchasing. " More info as easily as before. Thanks to the Simple rotary movement set the Continuously adjustable fibre optic light pointuntil the desired brightness is reached. That's all! Your new, intelligent IFiber takes care of the rest.

Movement activates the light point. (motion control)

A State-of-the-art position and motion sensor registers every movement and the position of the optics. A Controller interpreted this data so that the light point is there when you need it and still has a Maximum electricity savings can be realised.

Slope up & down function. (Angle-Control)

If you exceed the Shot angle of 45 degrees to up or down, the light spot uses your movements to check whether you are Uphill or downhill shoot.

Return after a few minutes no longer returns to the normal firing range, the Light point in rest & transport mode about.

The transport mode (Position Control & Angle Control)

In transport mode (when carried over the shoulder or when the rifle is lying on its side), the illuminated dot is no longer activated by movement.

Return with the Optics back to a normal shooting position your IFiber controller reacts to the movements again. A A short jolt or tilt activates the illuminated dot immediately returns to the preset brightness level. (IFiber Memory - Control)

How does IFiber-Control work?

State-of-the-art microtechnology is the logical answer. The new light point control has been equipped with the latest microtechnology.

A state-of-the-art position and movement sensor registers every movement and the position of the optics. A controller interprets this data so that the light point is there when you need it, while maximising energy savings.

The monitoring has a self-consumption that is not higher than the self-discharge of your battery.

IFiber BLS (battery life protection)

If IFiber has more than No activities for 3 hours can no longer be detected, the electronics are able to recognise themselves and the Switch off the LED completely.

This takes the control system into the 100% Switch-off for total battery conservation.  She is then no longer able to activate herself without help.

In this state, your battery is optimally protected against discharge by a consumer (control unit, light source).

Restart by reset

To restart the illuminated dot, simply turn the on/off switch back to the on position. back to the zero position for 2 seconds. The illuminated dot can then be used again as usual.

Extract bulletproof riflescopes with illuminated dot ifiber in the DDoptics riflescope shop