The DDoptics fibre optic riflescope illuminated dot II

Advantages of the Rifle Scope Illuminated reticleDifferent reticles for riflescopes. DDoptics uses the following 3 reticles for its riflescopes, depending on the target optics: " More info with Light pointThe choice of reticle and the associated mode of operation of the illuminated dot is of decisive importance when purchasing. " More info II

The Luminous point IIUnfortunately, fine details such as the light unit are often skimped on. And this has far-reaching consequences! Not so with DDoptics. " More info was developed by DDoptics in Dresden. This New generation illuminated dot II is used exclusively and for all products offered by DDoptics. Aiming optics installed.

New: The optional, intelligent additional control unit  IFiber from DDoptics.

Unfortunately, fine details, such as the light unit, are often saved. And that has far-reaching consequences! Not so with DDoptics.

1. The light point II is Dimmable as far as possibleuntil you can no longer see it.
2. You will see one illuminated dot and no other light within the optics. Reflections in the pipe are suppressed.
3. All Leuchtpunkt II LEDs are operated within the characteristic curve specified by the manufacturer. The voltage of your 3V battery is halved internally for this purpose! The Service life of the diode is thereby considerably extended.

To this end, the electronic circuit has been completely revised. In the lower dimming range, the Nighteagle can now be dimmed more finely up to the human eye level. EyeThe retina of our eyes has two different types of sensory cells or receptors, the cones (for day vision) and the rods (for night vision). " More info can no longer perceive the light spot. This is not easy to achieve with light-emitting diodes, as they normally go out when the breakdown voltage falls below a certain level.

Extreme Fine dimming at night is now even better possible

Below the SettingAlignment in binoculars refers to the parallel alignment of the two halves of the binoculars. " More info 4, the light point is no longer recognisable in daylight and can be dimmed down to the 0 setting. In the Position 1-3 the illuminated dot is only complete dark adaptation of the eye. The adjustment options of our illuminated dot II are therefore highest demands on night hunting fair.

It was particularly important here that the brightness of the daytime luminous point 5-12 is retained and is still fully recognisable even in strong sunlight.

Reflections in the inner tube are avoided with 99%. With the illuminated dot II, we have eliminated all the teething troubles of the first illuminated dot. Even when fully open, you will not see any reflections inside the tube.

All reticles of the DDoptics Nighteagle riflescopes are fitted with the new illuminated unit by hand. The illuminated dot can be customised to your specific requirements. When purchasing new optics, please ensure that the illuminated dot also fulfils the requirements of night hunting.

Special features of the Fibredot illuminated reticle

As the name suggests, the light point is a light point that real fibre optic light point. The light is therefore guided to the centre of the reticle by means of a fibre optic cable.

Advantages of reticles with Glass fibreA state-of-the-art position and movement sensor registers every movement and the position of the optics. A controller interprets this data so that the illuminated dot is there when you need it. " More info Light point:

1. The light is located exclusively in the Glass fibre strandand can therefore not lead to undesirable side and cross-fade effects.
2. The Light spot is extremely small (lowest possible target coverage)
3. With strong dimming, the light spot not only becomes darker but also finer, as the light is focussed on the Centre of the fibre optic cable concentrated.
4. At full power, the Light almost loss-free from the light source to the centre of the reticle. The illuminated dot fibre optic is fully illuminated and therefore suitable for daylight and backlighting.

And the target coverage?

The question of target coverage no longer arises with this type of illuminated dot, as it is the smallest possible, sensible target coverage.

To the DDoptics Telescopic sights with illuminated dot II and different magnifications (up to 4x , up to 6x , up to 10x , up to 15x , up to 20x or even up to 30x you get HERE